Quote:
Originally Posted by miamiten
Two full turns seems excessive even for very out of spec lights. Thats roughly 1/3 of the entire vertical motion range. There are two adjustment screws on each headlamp. The one closer to the centerline of the car is the vertical adjustment.
You did do this with the ignition only on, light switch in the on position (not auto), driver's door closed, and waited 80 seconds after closing the door to allow the stepper motor driver to go into diagnostic mode yes?
|
Someone said there is only 1 place for the adjustment.
I hope i did not do the horizontal adjustment.
I did it with ignition on (car off) in auto (when it is leveled), dont remember if the door was closed. Not sure about the diagnostic mode...
Tell me i adjusted the right one?
