Quote:
Originally Posted by kaiv
Well here's what I did.
Parts:
* Rear brake fluid reservoir from the BMW F650GS PN# 34 21 7 706 055
* 2 feet of vaccum line (Napa)
* 90° fitting is a 5/32" elbow connector PN#9873 (Napa)
* 1 M6 bolt (+ M6 washer)
Total cost: less than $40.
Notice the logo on the cap? Yup, Brembo!
Also notice the nipple on the cap is angled so it fits perfectly bolted to the ground bolt thingy on the side of the engine bay without bending the line.
I used a little under 2 feet of line just so I can unscrew/screw the cap without disconnecting anything.
I'll find out next weekend if this setup works as expected. |
Thank you for the part numbers and sharing. I needed this after coming from the track and saw all the fluid splashed for the first time.