BMW M3 Forum (E90 E92)

BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read

Go Back   M3Post - BMW M3 Forum > E90/E92 M3 Technical Topics > Mechanical Maintenance: Break-in / Oil & Fluids / Servicing
Steve Thomas BMW
Post Reply
Thread Tools Search this Thread
      11-13-2011, 05:15 PM   #1
Second Lieutenant

Drives: 08 e90 M3, 05 e46 zhp, 07 X3
Join Date: Jan 2009
Location: Near Boston MA

iTrader: (0)

Seating the oil cap gasket

Yesterday I needed top off the oil and found that when removing the cap, the gasket decided to come out of its seat in the cap. This bugged me mostly because of the problems that develop when the gasket is not seated correctly. After trying to work the circular gasket back into its "U" shaped channel in the cap with no success I found the following procedure works pretty well.

Work just the inside edge of the gasket into the channel leaving the outside edge floating above the outside edge of the channel it needs to seat into. Put the cap carefully back on the valve cover and tighten slowly. This should seat the outside edge pf the gasket into the channel. Then take the cap back off and inspect to make sure it seated correctly. If seated correctly, put the cap back on and check for leaks after driving a few miles just to be sure. A little film of oil on the gasket is always a good idea since you are probably going to clean the top of valve cover before you put the cap back on.
Appreciate 0
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -4. The time now is 08:45 AM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.,,,,,,,,, logo and trademark are properties of BIMMERPOST