FORUMS
- 5
![]() |
|
![]() |
| 06-14-2011, 07:29 PM | #1 |
|
Private
![]() |
Broken Exhaust Bracket
Just an FYI - I have been experiencing vibration and the dealer took a good look and found a broken exhaust clamp above the muffler. Exhaust needs to be dropped and clamp replaced. Quality of exhaust clamps not the best.
|
|
|
|
| 06-15-2011, 05:05 PM | #5 |
|
Private
![]() |
update: Dealer says the bracket is attached to the exhaust system and since it's stainless steel, it can't be welded back on. So they have to replace both mufflers and rear exhaust! Amazing. If your exhaust bracket breaks you will have to replace your whole exhaust.
|
|
|
|
| 06-15-2011, 05:11 PM | #6 | |
|
Major
![]() Drives: 2008 e92 M3 Join Date: Jan 2011
Location: PNW
|
Quote:
__________________
![]() Club 6MT 2008 E92 M3 6MT, AW/Blk Ext., brushed aluminum 2006 E46 M3 ZCP 6MT Carbon blk/blk(sold) ![]() 2001 E46 325Xi 5MT Jet Blk/Blk (sold) |
|
![]() |
|
| 06-15-2011, 05:19 PM | #7 |
|
Private
![]() |
|
|
|
|
| 06-15-2011, 05:23 PM | #8 |
|
Lieutenant Colonel
![]() Drives: '11 e92 M3 SG/FR Join Date: Jul 2005
Location: Huntington Beach, CA
|
You can probably buy an lightly used OEM exhaust here for less than $150. The $1200 credit is not that bad if the M Performance Exhaust is reasonably priced to begin with.
|
![]() |
|
| 06-15-2011, 05:30 PM | #10 |
|
Major
![]() Drives: 2008 e92 M3 Join Date: Jan 2011
Location: PNW
|
Not if you hit up one of the Dealer sponsors on here! I don't think you get the credit though if you don't buy it from them...
__________________
![]() Club 6MT 2008 E92 M3 6MT, AW/Blk Ext., brushed aluminum 2006 E46 M3 ZCP 6MT Carbon blk/blk(sold) ![]() 2001 E46 325Xi 5MT Jet Blk/Blk (sold) |
![]() |
|
| 09-22-2011, 11:32 AM | #12 |
|
Major General
![]() ![]() |
crap i think i have this as well. is it a buzz sound. ive been under there trying to figure out the issue and thought it was the new challenge sport x pipe i installed but nothing is loose or touching. they will probably not replace if that is the case because of the install of aftermarket center exhaust section.
__________________
![]() 02 Tiag e46 M3|6MT|GC plates|MCS c.o.|GC race control arms|GC bushings & bearings|BW eng. & tran. mounts|subframe kit|BW race shifter|BW Jaffster knob|Euro header|Eisenmann sport|K&N c.a.i.|Seibon CF hood|CSL bumper|CSL brakes|RS19s|SS lines|half cage|Recaro profi|Profi 2 harness|race pulleys|BMWpedals|Apex studs|1995 Ford Probe gt chump car| |
![]() |
|
| 09-22-2011, 12:14 PM | #13 |
|
Brigadier General
![]() |
|
![]() |
|
| 10-01-2011, 05:02 PM | #14 |
|
Major General
![]() ![]() |
finally got my exhaust rattle/buzz sorted out today. took it to the dealer and they said my brackets are fine on the exhaust just slight contact with the new xpipe and the black crossmember that runs under it. i had the car up on jacks today and put 2 washers 1 on each side of the center bolts that locate the exhaust onto the crossmember. i put them on the top side so held the exhaust a little higher up and created just enough space between the crossmember and exhaust to make my buzz go away.
![]()
__________________
![]() 02 Tiag e46 M3|6MT|GC plates|MCS c.o.|GC race control arms|GC bushings & bearings|BW eng. & tran. mounts|subframe kit|BW race shifter|BW Jaffster knob|Euro header|Eisenmann sport|K&N c.a.i.|Seibon CF hood|CSL bumper|CSL brakes|RS19s|SS lines|half cage|Recaro profi|Profi 2 harness|race pulleys|BMWpedals|Apex studs|1995 Ford Probe gt chump car| |
![]() |
|
![]() |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|