FS: TC Kline Ride Height Adjusters and #500 Eibach 10" linear springs

[mlifxs]

BIMMERPOST / Classifieds

Asking Price:

None

Item Interest

Springs still available... Ride Height Adjusters SOLD

Up for sale are TC Kline Ride Height Adjusters (RHAs) and Eibach #500, 10" 2.5" id springs.

Selling the RHAs for $140 shipped, CONUSA and the springs for $90 shipped CONUSA.

I purchased everything new around 4 months ago: Ride height adjusters direct from TC Kline and Eibach springs from Amazon. The adjusters sell for $160 + shipping, new, and Eibachs were $60+ each, shipped.

RHA's
According to the TCK website, the RHA's are compatible with E9X, both M and non-M, E82, and F30.

The RHA's are the same as what's sold with TCK E82 and E9X non-M and 1M and M3 coilover kits. They can be used with either 60MM springs or 2.5" id.. They will not work well with oem style springs with pig-tailed ends.

I put less than 3000 miles on both, and the adjusters were wrapped in Saran Wrap while on the car, so condition is basically as good as new.

On my 328i, I could achieve ZSP (non-M) ride height with the springs shown and the adjusters set to 1 5/8". So with these springs, I could lower the rear by just under 1 5/8". Of course, I could lower more, with shorter springs.

I used these with the springs shown, without a lower spring cushion or iso on the spring,. They made zero noise and spring linearity is more pronounced compared to oem style spring+cushion.

Springs

#500 lb springs were definitely a noticeable increase on a 328i and I would think the same for an E82. Somewhat less of an increase for 335i, but they do have the benefit of being very linear. The spring rate is lower than oem M3.

[mlifxs]

bump

[mlifxs]

bump

[mlifxs]

bump

[mlifxs]

bump

[mlifxs]

bumpj

[mlifxs]

bump