where to put kw edc modules?

oct1285 · 05-11-2011, 08:16 PM

Like the title says, where do I install the edc modules? Bought a used set of v3s off a forum member and it didn't come with instructions.

LateBraking · 05-12-2011, 02:21 AM

For the one module that controls the 2 fronts, bolt it down to your front strut tower brace, passenger side. The 2 modules that control the 2 rears, 3M tape them to the top of the trunk on the inside. Not the trunk lid, the actual inside trunk area.

oct1285 · 05-14-2011, 08:18 PM

do I need to let used coilovers settle? Because my driver side rear is lower than the right even though I set them to about the same height.

montreal red · 05-14-2011, 11:38 PM

Quote:

Originally Posted by oct1285

do I need to let used coilovers settle? Because my driver side rear is lower than the right even though I set them to about the same height.

drive it for a few days before measuring again. there shouldnt be too much of a difference in height. if there is, there might be an issue with one of the shocks or springs.

oct1285 · 05-15-2011, 10:59 AM

There's about .25-.5 in in height difference between the rears. I'll see where it settles after a week. But is that a big difference?

05-11-2011, 08:16 PM	#1
oct1285 Captain 54 Rep 608 Posts Drives: Out of warranty Join Date: Dec 2006 Location: TX iTrader: (4)	where to put kw edc modules? Like the title says, where do I install the edc modules? Bought a used set of v3s off a forum member and it didn't come with instructions.
	Appreciate 0 Tweet Quote

05-12-2011, 02:21 AM	#2
LateBraking Brigadier General 326 Rep 3,882 Posts Drives: Relatively Quick. Join Date: Sep 2008 Location: U.S.A. iTrader: (27)	For the one module that controls the 2 fronts, bolt it down to your front strut tower brace, passenger side. The 2 modules that control the 2 rears, 3M tape them to the top of the trunk on the inside. Not the trunk lid, the actual inside trunk area.
	Appreciate 0 Quote

05-14-2011, 08:18 PM	#3
oct1285 Captain 54 Rep 608 Posts Drives: Out of warranty Join Date: Dec 2006 Location: TX iTrader: (4)	do I need to let used coilovers settle? Because my driver side rear is lower than the right even though I set them to about the same height.
	Appreciate 0 Quote

05-15-2011, 10:59 AM	#5
oct1285 Captain 54 Rep 608 Posts Drives: Out of warranty Join Date: Dec 2006 Location: TX iTrader: (4)	There's about .25-.5 in in height difference between the rears. I'll see where it settles after a week. But is that a big difference?
	Appreciate 0 Quote