Installation of VRS (Type II) Rear Diffuser

frankzlin79 · 09-05-2009, 11:48 PM

I'm about to install a replica VRS (Type II) Rear Diffuser. I understand that I'm suppose to use the two stock screws. The diffuser comes with urethane tape. However, I read that epoxy should be used instead of the urethane tape. I've never used epoxy before. Is there a certain type of epoxy I should get?

SV Concepts III · 09-06-2009, 07:27 AM

The Type II installs over your factory diffuser with the preinstalled double sided tape.

frankzlin79 · 09-06-2009, 11:20 AM

Okay. So are you saying to not use epoxy for the rear diffuser?

What about a CF front lip? Should I be using epoxy for that?

09-05-2009, 11:48 PM	#1
frankzlin79 Lieutenant Colonel 265 Rep 1,696 Posts Drives: 2018 M3 Join Date: Oct 2008 Location: Houston, Texas iTrader: (5)	Installation of VRS (Type II) Rear Diffuser - Epoxy? I'm about to install a replica VRS (Type II) Rear Diffuser. I understand that I'm suppose to use the two stock screws. The diffuser comes with urethane tape. However, I read that epoxy should be used instead of the urethane tape. I've never used epoxy before. Is there a certain type of epoxy I should get?
	Appreciate 0 Tweet Quote

09-06-2009, 07:27 AM	#2
SV Concepts III Lieutenant General 375 Rep 17,017 Posts Drives: BMW Duh Join Date: Apr 2005 Location: Santa Clara iTrader: (13)	The Type II installs over your factory diffuser with the preinstalled double sided tape.
	Appreciate 0 Quote

09-06-2009, 11:20 AM	#3
frankzlin79 Lieutenant Colonel 265 Rep 1,696 Posts Drives: 2018 M3 Join Date: Oct 2008 Location: Houston, Texas iTrader: (5)	Okay. So are you saying to not use epoxy for the rear diffuser? What about a CF front lip? Should I be using epoxy for that? Last edited by frankzlin79; 09-06-2009 at 09:03 PM..
	Appreciate 0 Quote