Any pointers on trimming a shift boot and splicing wires?

[mdosu]

hey guys,

So I'm going to try to fit the F30 M Performance knob onto the E90 M3. I think I've figured out that I need to modify the F30 boot to fit on the the E90 boot frame.





So 2 things I need to do, that I need pointers, if anyone can help me out:

1. Any suggestions on making the cleanest cut on the F30 boot to seperate it from the F30 boot ring?

2. Any suggestions on gluing or attaching it to the E90 boot ring? I'm thinking just super glue. I'm also thinking about folding over itself to mask any glue marks to make it look clean, similar to what the pic looks like where the boot folds over the ring.

3. Any suggestions on how to properly splice and reconnect the wires? I'm assuming the plugs don't fit with a F30 knob. How do I know which wire goes to which?

here's an example of a ZHP install:

[Lerxst M4]

I was under the impression that the plugs DO match...as opposed to the ZCP knob.

Plug and play with the F30.

[mdosu]

Originally Posted by Lerxst M3

I was under the impression that the plugs DO match...as opposed to the ZCP knob.

Plug and play with the F30.

right, that's why I have to cut the wires.

[Lerxst M4]

Originally Posted by mdosu

right, that's why I have to cut the wires.

My bad...got my F series confused.

http://www.m3post.com/forums/showthr...highlight=knob

[Grail05]

How much is it? And did u get a apet number

[mdosu]

Originally Posted by Sean05

How much is it? And did u get a apet number

http://www.getbmwparts.com/partlocat...catalogid=4462

[THE TECH]

If the boot is glued on anything like the E9X ones are then you should be able to remove with the end of a screwdriver by gently pushing between the boot and the ring until you get all of it off the ring.

[mdosu]

Originally Posted by Lerxst M3

My bad...got my F series confused.

http://www.m3post.com/forums/showthr...highlight=knob

oops I also misread your post. Yes, I saw that the F10 M5 is a plug and play. The F30 likely is not.