|
|
09-15-2023, 01:54 PM | #155 |
Captain
502
Rep 647
Posts |
Direct bolt on but the E92 M brakes won't work. You need F3x/F8x or non-M E9x brakes, yeah?
Any info on geometry changes and part numbers? Edit: Did some digging. Part numbers are 31219500209 and 31219500210. They're $2,500 each. Geometry changes look like a little additional caster and camber. No mention of roll center anywhere. Last edited by amg6975; 09-15-2023 at 02:05 PM.. |
Appreciate
0
|
09-15-2023, 02:06 PM | #156 | |
Major
1417
Rep 1,370
Posts |
Quote:
Part numbers: 31219500210 31219500209 I have the knuckles scanned, I am calculating to compare with the price of BMW, I think I could make them cheaper, and also make it in such a way that it can be mounted in E and F series without any modification for abs sensors and calipers. |
|
Appreciate
1
atopa2002204.00 |
09-15-2023, 06:25 PM | #157 |
Lieutenant Colonel
1526
Rep 1,597
Posts |
Somewhat related... I'm thinking of doing F8X front uprights on my E92. I have lots of M4 bits from my M4 track car that I want to transfer over to an E92 M3, including the full BW Alcon BBK. Was thinking about swapping on the F8X front knuckles to use the Alcons on the E92 that way. Then source the E9X rear caliper bracket, or make a custom one for the rear kit.
When people do the F8X upright swap, are they still using E92 control arms? Can you use the F8X front tension arm if you do the upright as well? Or would you still need to use an E92 specific arm? tdott Would you happen to know? |
Appreciate
0
|
09-15-2023, 06:41 PM | #158 |
Captain
502
Rep 647
Posts |
|
Appreciate
0
|
09-16-2023, 02:40 AM | #159 |
Major
1417
Rep 1,370
Posts |
|
Appreciate
1
SYT_Shadow11500.00 |
09-17-2023, 10:25 AM | #160 | |
Lieutenant
166
Rep 478
Posts |
Quote:
Tension strut hole to hole is the same IIRC. The other arm will put your wheel into the fender liner.
__________________
Bilstein CS | Rays ZE40 | Solid/spherical front / rear.
YouTube |
|
Appreciate
1
911r897.00 |
09-17-2023, 10:31 AM | #161 | |
Brigadier General
3956
Rep 3,994
Posts |
Quote:
Not sure what changes would be if using f8x tension arms.
__________________
|
|
Appreciate
1
tsk941526.00 |
Post Reply |
Bookmarks |
|
|