|
|
|
KEEP M3POST ALIVE BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER LINK! |
Post Reply |
|
Thread Tools | Search this Thread |
05-08-2011, 11:08 PM | #1 |
Enlisted Member
8
Rep 31
Posts |
BBS LM-R 19*8.5 et32 and Brembo 380mm 6piston BBK question
hi everyone,
I have question here , i just got one set of BBS LM-R 19*8.5 et32 front , and 19*10 et20 rear, and i also got the brembo 6 piston front and 4 piston rear bbk. both are 380mm rotors, and tire size are Pilot Super Sport 245/35/19,275/35/19is that fit the wheels without spacer ? ? BBS manufactory also give me two 10mm spacer in case.. can i just install that without spacer ?? |
05-08-2011, 11:12 PM | #2 |
Banned
89
Rep 1,315
Posts |
I tried that before, it wouldn't work. It only needs 2-3mm more clearance without spacers on front's. So, it turns out it would work unless you use a massive spacer.
However, if you don't care the paint on your Brembo calipers, you would be fine running these wheels on streets since they rub just a little. BUT, it's better to be safe than sorry. |
Appreciate
0
|
05-09-2011, 12:11 AM | #3 | |
Enlisted Member
8
Rep 31
Posts |
Quote:
|
|
Appreciate
0
|
05-09-2011, 12:16 AM | #4 | |
Banned
89
Rep 1,315
Posts |
Quote:
If you take the car to the track, I would recommend change to longer studs (search ARP studs) with open end lug nuts. Again, it depends on your usage. I wouldn't too worry about it. |
|
Appreciate
0
|
05-09-2011, 12:23 AM | #5 | |
Enlisted Member
8
Rep 31
Posts |
Quote:
|
|
Appreciate
0
|
05-09-2011, 12:40 AM | #6 |
Banned
89
Rep 1,315
Posts |
|
Appreciate
0
|
05-09-2011, 12:44 AM | #7 |
Enlisted Member
8
Rep 31
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|