|
|
02-22-2013, 09:41 PM | #1 |
Member
43
Rep 268
Posts |
removing cf splitters and spoiler
Hello, since I am getting rid of my e90 m3 I was considering selling my cf splitters, spoiler, and mirror caps.
Problem is that the splitters and spoiler were glued by the dealer.... any idea on how I can take them off? I dont want to put them under hot air and possibly ruin the clear coat in the process... |
02-22-2013, 10:38 PM | #2 |
Brigadier General
915
Rep 3,456
Posts
Drives: Harrop E90 M3
Join Date: May 2011
Location: Colorado Springs
|
If you can get them off, that adhesive is pretty good stuff. It's gonna be tough not to damage the paint and the carbon bits in the process. Probably best to sell as is. The mirror caps are fairly simple to remove. Pop the glass off and release the tabs from from inside the mirror to prevent damaging them.
|
Appreciate
0
|
02-23-2013, 02:49 AM | #3 |
Colonel
180
Rep 2,446
Posts
Drives: '11 E92 M3 DCT
Join Date: Jun 2011
Location: Calgary, Ab
|
Use a hair dryer and some fishing line.
You will not damage the paint or clear coat. The dealer most likely used double sided tape. The mirror caps pop right off.
__________________
11' E92 M3 Space Grey | DCT | ESS VT2- 625 | Gintani Race (valved) + Quad Res Catless X-Pipe | KW Sleeve's | GC Camber Plates|Arkym Diffuser | Vorsteiner VRS Lip | P3 Boost Guage | Stud Conversion PHOTO's: Click Here ESS VT2 625 PHOTOS: Click Here |
Appreciate
0
|
02-23-2013, 06:40 AM | #5 | |
Colonel
336
Rep 2,940
Posts |
Quote:
Leave it as is.
__________________
Audi S6 * Audi S3 * Porsche Cayman GTS
--Former BMW M3 owner |
|
Appreciate
0
|
02-23-2013, 10:48 AM | #6 |
Lieutenant
16
Rep 421
Posts |
You're going to run the risk of damaging your paint which will cost more to fix than you'll get out of selling the parts. Especially if they're damaged in the removal which will leave them pretty much worthless. I think you'll be doing yourself a huge favor by just leaving it alone and selling as-is.
|
Appreciate
0
|
02-23-2013, 10:53 AM | #7 |
Major General
1250
Rep 6,912
Posts |
Dealer definitely used betalink. Best bet is heat and fishing line. If it doesn't give....I would abort the attempt. You won't damage the paint but you may well break the spoiler in half if you pull too hard.
__________________
2022 Dravit/Fiona M3cx - Dinan midpipe w/VC, NW Carbonhaus CF, AST Springs, FC Spacers...more to come!
2016 Indi F80 M3 - SMB|Amaro | Mode Carbon | ESS | Akra EVO | KW HAS...SOLD 2012 MR e92 M3 DCT, ESS SC, Brembo BBK, BBS FI... GONE but not forgotten! 2008 AW e92 M3 6MT, ESS SC, BBS LM's...SOLD! |
Appreciate
0
|
02-23-2013, 12:07 PM | #9 |
Captain
197
Rep 985
Posts |
I would leave them on also. I tried removing the splitters before selling my last car, but the damn Betalink made sure they weren't coming off.
|
Appreciate
0
|
02-23-2013, 08:03 PM | #10 |
Member
43
Rep 268
Posts |
Well, the dealer absolutely used the adhesive and they do not wan't to come off, I did not want to risk it so left it as is after attempting to take them off..
only mirror caps for sale now... taking offers... |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|