Engine malfunction

BPMSport · 08-12-2015, 05:17 PM

Quote:

Originally Posted by Stein

Quote:

Originally Posted by Mike Benvo

Also fyi for anyone else experiencing the vacuum fault.. A lot of times this fault will throw cars into limp mode that recently had a brake fluid flush or change. The sensor is located directly under the brake fluid reservoir and if any fluid gets on it, the car will keep getting thrown in limp mode. Seen it happen a number of times. Hope this helps.

Does the sensor need to be replaced? I just had my brake fluid flushed and the car has gone into limp mode twice in 5 days since then. Both times I turned the car off and on and it ran fine.

Yup, I would replace it. You could try cleaning up the sensor as well.

nolaman1970 · 03-15-2018, 09:59 PM

I replaced the Brake Booster Pump inside of the drivers side wheel well and the car has not had the code since. It was putting the car in limp mode.

03-15-2018, 09:59 PM	#24
nolaman1970 Private 57 Rep 90 Posts Drives: 2011 BMW M3 E93 Join Date: Feb 2018 Location: Marrero, LA iTrader: (0) Garage List 2011 BMW M3 [0.00]	Brake Booster Pump I replaced the Brake Booster Pump inside of the drivers side wheel well and the car has not had the code since. It was putting the car in limp mode. Last edited by nolaman1970; 03-16-2018 at 11:26 AM..
	Appreciate 0 Quote