|
|
04-19-2013, 02:03 PM | #1 |
Brigadier General
721
Rep 3,964
Posts |
replacing bank 1 post cat oxygen sensor myself
how far up is the harness for this? Any help greatly appreciated. I don't think I should have to drop the xpipe...
Dave
__________________
2020 Ford Mustang GT 6MT PP1 444rwhp
(Sold)2013 M3 Coupe-MR/BLK ZCP, 2011 M3 Coupe-MR/Blk 2007 Porsche 997C2S Speed Yellow/Blk sport seats 2004 BMW M3 Imola/Blk |
04-19-2013, 02:32 PM | #2 |
Dingleberries
76
Rep 1,246
Posts |
Harness is no problem. Clearance to pull the O2 sensor out will be a little tight. I had my xpipe down when I removed the sensors and haven't tried to do it when Xpipe was installed.
|
Appreciate
0
|
04-19-2013, 10:36 PM | #5 |
Brigadier General
721
Rep 3,964
Posts |
Thanks to everyone for your help...Malek been itching to stop by your shop anyway...may take you up on your offer. Thanks bro...
Dave
__________________
2020 Ford Mustang GT 6MT PP1 444rwhp
(Sold)2013 M3 Coupe-MR/BLK ZCP, 2011 M3 Coupe-MR/Blk 2007 Porsche 997C2S Speed Yellow/Blk sport seats 2004 BMW M3 Imola/Blk |
Appreciate
0
|
04-21-2013, 07:21 PM | #6 |
Captain
107
Rep 805
Posts |
I just did my bank 2 pre-cat 02 a couple weeks ago...pretty easy. Not exactly 10 minutes for a first timer (I tend to take my time), but no more than 30 when you count setup time (jacking car up, jack stands set up, etc). You have to drop the metal shield to get to the xpipe and sensors. That's about 10 bolts I think...but once you get that off it's fairly easy access.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|