Sponsored by The Tire Rack

[mdoughty]

anyone know if these 18in wheels will clear 380mm bbk kits? 18x10 with 27mm offset

[STALKER]

Originally Posted by mdoughty

anyone know if these 18in wheels will clear 380mm bbk kits? 18x10 with 27mm offset

They are suppose too, but I do recall one member here purchased a set and he did have some clearance issues with his BBK.

[M3SQRD]

Originally Posted by STALKER

They are suppose too, but I do recall one member here purchased a set and he did have some clearance issues with his BBK.

Yes, there were initial fitment issues but then the wheels were shipped back to Forgeline and reworked so they'd clear the Brembo 380 mm BBK. I'm assuming they now have the correct Brembo 380 mm measurements - call them directly to verify, they won't mind.

I have a set of the ZX3R - great wheel!

[STALKER]

Originally Posted by dbarnes

Yes, there were initial fitment issues but then the wheels were shipped back to Forgeline and reworked so they'd clear the Brembo 380 mm BBK. I'm assuming they now have the correct Brembo 380 mm measurements - call them directly to verify, they won't mind.

I have a set of the ZX3R - great wheel!

Good to know.
Seen a few sets of these on some Pcars.

[THE TECH]

I have a set on my Chevelle. They look great.

[mdoughty]

good one. i'm old enough to remember when jet nuts were all the rage. i think the drag car guys used to call them trick wheels as opposed to the krager mags which were pretty ubiquitous back in the day

Originally Posted by THE TECH

I have a set on my Chevelle. They look great.