Sponsored by The Tire Rack

[VegasEgg]

I've searched but can't find a answer for my exact set up. According to tire rack the PSS' in 265/30/19 have a OD of 25.3" on a 9.5" rim and 295/30/19 OD of 26" on a 10.5" rim. I've read that on average a change of .5" in the with of the rim will add/subtract .2" to the OD. That would make the 265= 25.5" OD & 295= 26.2" OD on ZCP's and only a .1" difference between the OD's of the stock Conti CS3's.

Would I be able to run the PSS 265/30/19 & PSS 295/30/19 on ZCP wheels w/ stock suspension without rub? Would I have to pull the pins up front to get more camber?

[quads]

I've run 275/30/19 295/30/19 on zcp - search my posts for pictures

[VegasEgg]

Originally Posted by 4sevens.com

I've run 275/30/19 295/30/19 on zcp - search my posts for pictures

I've seen yours and it looks great but you have camber plates correct? Have you had any issues with the DSC?

[quads]

Originally Posted by Jrollsp

I've seen yours and it looks great but you have camber plates correct? Have you had any issues with the DSC?

Those pictures were before camber plates. Pins were pulled and front camber maxed out but not for the tires.

After my GC kit it was lowered even more and rubs a bit at full lock.

[VegasEgg]

Originally Posted by 4sevens.com

Those pictures were before camber plates. Pins were pulled and front camber maxed out but not for the tires.

After my GC kit it was lowered even more and rubs a bit at full lock.

Nice! Just to confirm... you ran PSS 275/30 & 295/30 on a completely stock ZCP suspension without any issues or rubbing? Do you recommend I pull the pins or is that not necessary?

[quads]

Originally Posted by Jrollsp

Nice! Just to confirm... you ran PSS 275/30 & 295/30 on a completely stock ZCP suspension without any issues or rubbing? Do you recommend I pull the pins or is that not necessary?

I pulled pins to reduce shoulder wear from track. If you're not tracking it's probably not needed. even with pins pulled and camber maxed out it wasn't enough for me on track

[Dave07997S]

Originally Posted by Jrollsp

Nice! Just to confirm... you ran PSS 275/30 & 295/30 on a completely stock ZCP suspension without any issues or rubbing? Do you recommend I pull the pins or is that not necessary?

E90s may rub in the rear a tad while E92s seem to get by without any rubbing.

Dave

[quads]

Actually the read rubbed just a slight bit at full compression with 295/30/19 PSS's It was very slight and shaved off just a tad bit of the outside shoulder. Shaved isn't the right word - more like rubbed off a little bit of rubber.