 |
|
 |
|
|
|
|
|
|||||||||
Post Reply |
|
|
Thread Tools | Search this Thread |
| 05-13-2014, 11:27 AM | #1 |
|
Captain
 
86
Rep 623
Posts |
On drop springs. Is there enough adjustment to get to factory alignment specs?
In Hawaii anytime a vehicles suspension is modified, we need to get a "reconstruction permit" to be legal to drive. Alignment needs to be able to go back to within factory parameters to pass the recon permit. Is there enough adjustment in the factory system to put it back within factory spec? Vehicle is dropped on BG springs.
 Last edited by Harry Da Hamster; 05-13-2014 at 11:37 AM.. |
| 05-13-2014, 01:00 PM | #2 |
|
Lieutenant
30
Rep 521
Posts |
Most likely. Front camber might be a bit tricky depending on how low you go (since the max negative value is only -1.5 for some reason - the car handles much better around -2.5) but the rear will be a non-issue.
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
