|
|
08-11-2013, 01:41 PM | #1 |
Brigadier General
569
Rep 3,742
Posts |
How to replace boots for DCT and e-brake?
Got the iND tri-stitched boots for my DCT and e-brake. Not sure how to remove the OEM ones. I searched for threads on this but came up empty. I saw a lot of posts describing it as very easy, but nothing about how to actually do it. Any ideas?
|
08-11-2013, 01:44 PM | #2 |
Brigadier General
145
Rep 3,329
Posts |
ebrake is easy just pull on it and it pops off the handle but remember to unclip the boot first. its easily just a pull off item.
the shifter i don't know.
__________________
F80 ///M3 6MT Avus Blue ZCP |
Appreciate
0
|
08-11-2013, 02:05 PM | #3 |
Brigadier General
8908
Rep 4,107
Posts |
The DCT boot is simply snapped in place. You can gently pull it off or use a trim removal tool to pop it off... IND sends you the entire OEM kit so it simply snaps back in.
FYI on the e-brake boot. You will need a small zip tie to secure the new boot to the handle. Pretty sure IND includes one but I recall my IND kit came without one. Had one in the house so not an issue... This is a DIY for a MT boot but getting the original off is the same process. Once off it is a simple plug in and re-install the boot by snapping back into place. http://www.m3post.com/forums/showthr...=%2Bdct%2Bboot
__________________
2021 X3 M40i
1974 2002tii, Inka, 5 sp manual BMWCCA # 327475 Last edited by kscarrol; 08-11-2013 at 08:26 PM.. |
Appreciate
0
|
08-11-2013, 07:57 PM | #4 |
Brigadier General
980
Rep 4,001
Posts |
DCT Knob comes off by pulling it with some force, be careful you dont punch yourself on the chin
__________________
Grigio Telesto M4, 6MT. Coyote 5.0 F-150 991 GT3 |
Appreciate
0
|
08-14-2013, 12:32 AM | #6 | |
Brigadier General
569
Rep 3,742
Posts |
Quote:
It was a ///Miracle. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|