|
|
04-26-2012, 06:59 PM | #23 |
Major General
1573
Rep 8,076
Posts
Drives: 11 E90 M3 Individual
Join Date: Mar 2006
Location: Houston, TX
|
The Stoptech rotors will last longer from my experience on my 330. I had a BBK which used the OEM euro E46 M3 rotor which is a similar design to the E90. With that said, you can't be lazy and not switch pads from street to track. If you use track pads on the street, they'll chew up your rotors. The benefit of having the ST BBK is that its x100 easier to swap pads so no excuse.
I wanna say the ST60 kit fits under the rear OEM 18s. In fact I will try and remember to do a test fit on 5/5. I wanna say the front OEM 18s may fit with a spacer from the pics I've seen of the rear OEM 18s over the ST60s. I do agree that the OEM brakes leave something to be desired...I'm going through my front PF01s pretty quickly. About half done with 3 days of use.
__________________
2018 F30 320iX Melbourne Red
2011 E90 M3 Monte Carlo Blue 2004 E46 M3 Imola Red 2000 E36/7 Z3 Steel Blue Last edited by bigjae1976; 04-26-2012 at 07:19 PM.. |
Appreciate
0
|
04-26-2012, 11:21 PM | #25 |
78
Rep 684
Posts |
Vibration could be due to two reasons. 1) pads melting onto the rotor, and/or 2) pad compound incompatibility. I once used Pagid and Project Mu on the same rotor and I experienced quite a bit of vibration.
OE 18s will fit StopTech 380 mm front when used with a 10 mm spacer (5 mm too I believe) http://www.m3post.com/forums/showthread.php?t=604764 My first set of StopTech 380 front rotors, when used with StopTech Street Performance pads, lasted over 20 track events. The rears still have more than 50% life left. I typically recommend my customers to try out the Street Performance pads first on the BBK. This combo should be quite capable. If this is not good enough, you can always order some race pads later. It is perfectly fine to get a front BBK only. I am currently running Brembo 365 front with stock rears. I also have customers who are very experienced drivers use front StopTech only (355 and 380) without issues. Plus, you can always tune the brake balance by using different pads front/rear. Hope this helps
__________________
|
Appreciate
0
|
04-27-2012, 07:36 AM | #26 | ||
Brigadier General
3663
Rep 3,422
Posts |
Quote:
Intrigued by the possibility of getting the ST-60 under my 18's.. Quote:
That's great rotor life. I certainly wouldn't expect more. As above, I'm interested in the ST-60 possibility. Any feedback from anyone who has actually run this setup? If I go the ST-60 route and have issues due to fitment, then it's Probably a stupid question, but any concerns over running 10 mm spacers only up front then? Thank you. |
||
Appreciate
0
|
06-21-2012, 07:44 PM | #27 |
Brigadier General
3663
Rep 3,422
Posts |
Time to update this 'here's my problem' thread with the resolution..
Stoptech ST-40 fronts with Pagid RS-29 pads. First track day is next Monday, but if my two relatively lengthy and aggressive bedding sessions are any indication, performance with this setup is absurd, ridiculous.. f-ing awesome. A bottomless pit of stopping power. My tires are now the weak link. Quiet as a mouse so far. No squealing whatsoever, and sufficient when cold. I plan to leave the Pagids in full time unless characteristics change. Thanks to Omar @ Velos Designwerks for the Stoptech kit and Richard @ M-World for the pads. |
Appreciate
0
|
06-22-2012, 06:08 AM | #29 |
Brigadier General
3663
Rep 3,422
Posts |
WHOA! OMG! SNOWTIRES!? Slow down Sherlock.
I was thinking that these are my tires: http://www.tirerack.com/tires/tires....wall=Blackwall You perhaps are thinking that these are my tires: http://www.tirerack.com/tires/tires....emeContact+DWS But the DWS are actually not designated snow tires. So what are you thinking? |
Appreciate
0
|
06-22-2012, 09:46 AM | #31 | |
Brigadier General
3663
Rep 3,422
Posts |
Quote:
One thing I will say about the Contis is that they've got life. Almost 10k miles and 2 track days (one wet) and they've got lots of tread left. They were also quite good on the wet track day. Dry, not so much. |
|
Appreciate
0
|
06-22-2012, 09:56 AM | #32 |
Brigadier General
3663
Rep 3,422
Posts |
Right.. I'll exchange some life for stickiness at this point.
|
Appreciate
0
|
06-22-2012, 11:13 AM | #33 | |
Captain
80
Rep 961
Posts |
Quote:
I bought a set of DW's recently for the Mustang and they're good tires, at least now when they're new. Tirerack was clearing my size for $100 each, so it's pretty much impossible not to be happy with them. I did a soaking wet track day at the Ridge with them, and they were great. In the dry, they'd melt. |
|
Appreciate
0
|
06-22-2012, 11:34 AM | #34 | |
Brigadier General
3663
Rep 3,422
Posts |
Quote:
Well I'm certainly not advanced enough to melt them, and they do seem relatively sturdy. 10k miles, 2 track days -- one of which was at Homestead where it was ~80 degrees and I did all 5 full sessions -- and they've got lots of life remaining. We'll see how they hold up next week with the Stoptechs torturing them. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|