|
|
12-14-2013, 11:37 AM | #1 |
Major
108
Rep 1,042
Posts |
USB MULF2 Retrofit - Help Needed
hey guys in some desperate need of help here if anyone has knowledge on this area.
I am trying to retrofit a MULF2High SVS to my e92 that has phone prep (640). I am using the white block cable from the phone prep to the blue connection on the MULF (i didnt change any wires and noticed it got power) The wires I have are as follows into the blue block: Black connector: 36 - brown 33 - yellow 31 - grey 19 - black 21 - clear 17 - red/green 15 - red/black 3 - blue 1 - yellow Grey block 37 - white / yellow 38 - blue / white 46 - green 50 - grey/blue I tried both this setup as well as a direct connection to the radio most wire for retrofitting a MULF2. I cant get INPA to identify it for the life of me. not sure whats wrong. I see the red light from the MULF come on momentarily then it shuts off. Here is the pin config i am using for the MULF2 - taken from my Phone Prep package. Maybe its not wired correctly to provide constant power?? It lights up the fiber cable for about 30 seconds then turns off. I am unable to see the MULF in INPA and tool32. I get the error unable to communicate w control unit. It seemed like others on this thread were able to solve this. Any insights GREATLY appreciated. |
Post Reply |
Bookmarks |
|
|