220M square set-up - Page 2

GOLFFRR · 04-11-2011, 07:46 PM

Quote:

Originally Posted by Malekreza11

No. 19x10 359M rear wheel with 265-35 PS2 tires.

Suspension, H&R lowering springs on a ZCP car.

Malek knows whats up

Dave07997S · 04-11-2011, 10:54 PM

I would like to run a 275/30/19 front with the 359 rear wheel and my current 285/30/19 for the rear.

What you think Malek??

Dave

DCC · 04-11-2011, 11:08 PM

Quote:

Originally Posted by ring007

I have a ZCP coupe and am running a square setup with 220's on the track. My first setup using 265/35 PS2's on the front caused rubbing on the rear part of the driver side wheel well liner at full lock (passenger side was fine). Didn't shred the tire in the two sessions that I used it like that, but did wear the liner. I have been running 275/30 AD08's (25.5" diameter) all around with good luck since then though.

so you ran a 19x9.5 220 wheel up front with 265/35/19 and it rubbed the liner only on one side? is this a bad rub or just a slight rub?

DCC · 04-11-2011, 11:10 PM

Quote:

Originally Posted by Malekreza11

No. 19x10 359M rear wheel with 265-35 PS2 tires.

Suspension, H&R lowering springs on a ZCP car.

Based on your experience, I should be save running a 19x9.5 220M rear wheel with 265/35/19 up front with a stock non-ZCP suspension...yes?
Thanks

Malek@MRF · 04-12-2011, 02:56 AM

[quote=DCC;9346940][quote=Malekreza11;9344821]No. 19x10 359M rear wheel with 265-35 PS2 tires.

Suspension, H

Malek@MRF · 04-12-2011, 02:57 AM

Quote:

Originally Posted by Dave07997S

I would like to run a 275/30/19 front with the 359 rear wheel and my current 285/30/19 for the rear.

What you think Malek??

Dave

This is not a problem at all. The 30 series opens a lot of room.

DCC · 04-12-2011, 07:18 AM

[quote=Malekreza11;9347850][quote=DCC;9346940]

Quote:

Originally Posted by Malekreza11

No. 19x10 359M rear wheel with 265-35 PS2 tires.

Suspension, H

huh?....

ring007 · 04-12-2011, 08:38 AM

Correct. Funny isn't it.

Not sure how to differentiate between a bad vs. slight rub. I can tell you though that it rubbed through the liner in a spot about 1 inch long (top to bottom) and about 1/8" wide side to side.

Quote:

Originally Posted by DCC

so you ran a 19x9.5 220 wheel up front with 265/35/19 and it rubbed the liner only on one side? is this a bad rub or just a slight rub?

ring007 · 04-12-2011, 08:40 AM

Interesting. Maybe a 10" wheel stretches the tire enough to lower the diameter sufficiently to avoid rubbing? Never thought about that as a solution. Guess I could measure the diameter or my 359 street wheels to see if the 10" width makes a difference.

[quote=DCC;9348458][quote=Malekreza11;9347850]

Quote:

Originally Posted by DCC

huh?....

DCC · 04-13-2011, 01:53 PM

Quote:

Originally Posted by ring007

Correct. Funny isn't it.

Not sure how to differentiate between a bad vs. slight rub. I can tell you though that it rubbed through the liner in a spot about 1 inch long (top to bottom) and about 1/8" wide side to side.

On which part of the liner?
Thanks

Tptboy · 12-30-2011, 02:36 AM

Am I to understand that a square set of rear 220 wheels with 275-30-19 ad08's all around fits a stock car without problems? I am about to pull the trigger on this.

jphughan · 06-26-2012, 12:19 PM

Bump on this thread since it doesn't have a definitive answer to the OP's original question (nor can I find an answer in any other thread), and I'm contemplating this to get around some understeer that's now in my way as I've increased my skills on the track -- but I would be running this setup full-time since I don't yet want to deal with dedicated track wheels and tires. Will OEM rear 220Ms with OEM rear tires fit on the front of a non-ZCP M3 with no modifications? If so, will they protrude outside the fender, and if so by how much? And will they rub at all, and if so how much wheel lock will it take, and does it just tear up the fender liner or will it damage the tire as well?

Boosted-M · 07-02-2012, 02:16 PM

Square setup looks and drives great!

I have a set of rear M3 220M wheels up for sale or trade for fronts.. Here is the link

http://www.m3post.com/forums/showthread.php?t=705925

FVM3 · 05-19-2013, 03:18 PM

slammed

04-11-2011, 10:54 PM	#24
Dave07997S Lieutenant Colonel Drives: 2011 BMW M3 ZCP Coupe Join Date: May 2009 Location: Playa del Rey, CA Posts: 1,975 iTrader: (0)	I would like to run a 275/30/19 front with the 359 rear wheel and my current 285/30/19 for the rear. What you think Malek?? Dave __________________ 2011 M3 Coupe-MR/Blk Turner Test Pipes, AFE pulley, Megan Catback/AFE Stg.2. 255/285 tires. Previous Rides: 2007 Porsche 997C2S Speed Yellow/Blk sport seats 2004 BMW M3 Imola/Blk

04-12-2011, 02:56 AM	#27
Malek@MRF BimmerPost Supporting Vendor Drives: E92 ZCP Melbourne 6MT Join Date: Jan 2008 Location: Irvine, California Posts: 2,832 iTrader: (5)	[quote=DCC;9346940][quote=Malekreza11;9344821]No. 19x10 359M rear wheel with 265-35 PS2 tires. Suspension, H __________________ MRF on Facebook Southern California's largest & most reputable E9x M3 forced induction & suspension facility. *"Performance; Uncompromised."*

06-26-2012, 12:19 PM	#34
jphughan Colonel Drives: 2011.75 M3 E92 6MT Join Date: Mar 2011 Location: Austin, TX Posts: 2,168 iTrader: (0)	Bump on this thread since it doesn't have a definitive answer to the OP's original question (nor can I find an answer in any other thread), and I'm contemplating this to get around some understeer that's now in my way as I've increased my skills on the track -- but I would be running this setup full-time since I don't yet want to deal with dedicated track wheels and tires. Will OEM rear 220Ms with OEM rear tires fit on the front of a non-ZCP M3 with no modifications? If so, will they protrude outside the fender, and if so by how much? And will they rub at all, and if so how much wheel lock will it take, and does it just tear up the fender liner or will it damage the tire as well? __________________ 11 M3 E92 Le Mans \| Black Nov w/ Alum \| 6MT \| Premium 2 \| Convenience \| 19" \| EDC \| Prem Audio \| Moonroof \| BMW Apps \| Vorshlag Adjustable Camber Plates \| StopTech Street Perf Pads \| Castrol SRF Fluid \| ModMyNav.com rear camera Last edited by jphughan; 06-26-2012 at 12:40 PM.

05-19-2013, 03:18 PM	#36
FVM3 Brigadier General Drives: 2011 E93 M3 Join Date: Sep 2010 Location: Los Angeles Posts: 4,850 iTrader: (2)	slammed __________________ 2011 E93 DCT

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

12-30-2011, 02:36 AM	#33
Tptboy Enlisted Member Drives: 2008 Red Coupe Join Date: Sep 2011 Location: Houston Posts: 47 iTrader: (0)	Am I to understand that a square set of rear 220 wheels with 275-30-19 ad08's all around fits a stock car without problems? I am about to pull the trigger on this.

07-02-2012, 02:16 PM	#35
Boosted-M Private First Class Drives: BMW ///M Join Date: Apr 2011 Location: Northeast Posts: 199 iTrader: (0)	Square setup looks and drives great! I have a set of rear M3 220M wheels up for sale or trade for fronts.. Here is the link http://www.m3post.com/forums/showthread.php?t=705925