FORUMS
- 5
![]() |
|
![]() |
|
![]() KEEP M3POST ALIVE BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER LINK! |
|||||||||
![]() |
|
|
Thread Tools | Search this Thread |
| 07-26-2008, 12:29 PM | #1 |
|
Dishonorable Discharged
|
I have been able to fit TR Motorsport 18"x10" with 295/30/18 with no issues in the rear and a 18"x10" front 285/30.
Has anyone fit something larger (width only) on the rears? 18 inch is important over other sizes because of DOT legal track tire sizes available. I think that the car needs a 305 or 315 tire. Speculation is appreciated if you have some facts. (Oh wait, speculation is seldom based on facts). |
![]() |
|
| 07-27-2008, 09:38 AM | #4 | |
|
Second Lieutenant
![]() |
I would like to see pics of that setup if possible. Thanks.
Quote:
|
|
![]() |
|
| 07-27-2008, 10:22 AM | #5 | |
|
Veni Vidi Vici
Drives: '11 JB/BBe-6sp-e90 Join Date: Jul 2008
Location: Macungie PA
|
Quote:
But back to the original question, I don't think there is a lot of room in the rear for much larger tires than stock, unless the offset is changed to something like et30 - et35. Then you have to worry if there is enough room to the inside. I'm actually surprised a 295 fit. Did you check to see if it clears with the suspension loaded (eg at the track)? Unless I get a very good price for them when I sell the e46, I intend to run my BBS REs on the e90 for track days. 10.5x18 ET28 rear with 285/30-18 PSCs and 9.5x18 ET35 in the front (with 10mm spacers) and 265/35-18 PSCs. My street set-up, if I confirm it works, will be two sets of OEM 18s. Square set-up of 9.5x18 with 265s in the summer, and square set-up of 8.5x18 with 245s for winter. My 2 cents worth. |
|
![]() |
|
| 07-27-2008, 11:21 AM | #6 |
|
Hamann M3 Fan
Drives: 2008 E92 Jerez Black M3 Join Date: Feb 2008
Location: Killeen, Texas
|
![]() ![]() ![]() ![]() ![]()
__________________
![]() JZB,6MT, My mods 360 Forged 20inch wheels,VF540 Supercharger,Hamann CF roof spoiler,H&R springs,CF grills,Hamann rear trunk spoiler,Hamann Side Skirts, ARKYM full CF bumper, Gintani Race exhaust, AA X-pipe catless,RPI scoops,AA SSK, JZB painted side grills w/tinted markers, Arkym CF Double Sided Vented Hood,Arkym CF rear Diffuser |
![]() |
|
| 07-27-2008, 11:27 AM | #7 | |
|
Dishonorable Discharged
|
Quote:
Radiation, 10.5 would be interesting. But the 9.5 fronts are too small. sytemthree, not a problem of oversteer, problem is too high a tire temp(probe at 215 deg) I could drive slower, but,NO. 285'd up front do not push, but again are very hot (205 deg) Before others ask yes the tire pressure was OK at 37psi and yes it was a hot day. Tires were Yoko Advan A048's, new not shaved. vincmo, I'll try to find some. swanp2, Offsets are 44 front 25 rear, no spacers. |
|
![]() |
|
| 07-27-2008, 11:38 AM | #8 |
|
Veni Vidi Vici
Drives: '11 JB/BBe-6sp-e90 Join Date: Jul 2008
Location: Macungie PA
|
Is this any better? These are the 17 pound each forged magnesium BBS wheels I'd like to use on the e90 for track days. The rears barely clear both inside and out on the e46. I expect there will be more room in the current M3
|
![]() |
|
| 07-27-2008, 12:08 PM | #9 |
|
Veni Vidi Vici
Drives: '11 JB/BBe-6sp-e90 Join Date: Jul 2008
Location: Macungie PA
|
44 front??????
Aren't those the 18x8.5 TR Motorsports wheels? I thought you were running 18x10 ET25 on all four corners (an awesome combination, if it fits), and just questioning what tire sizes to use?. Personally, If I had a set of the TR Motorsports wheels in 18x10 ET25, I'd be running Hoosier R6 tires in 275/35-18 on all four corners. Temps, camber and pressures aside, I think that would yield your fastest laps. Probably only get a weekend or two out of a set, though. Fronts might be camber challenged. I wonder of GC will have camber plates out soon for this car. If tire wear is an issue, I'd consider the Michelin PSCs, 285/30-18 again in a square set-up. They would be less sensitive to camber settings, too. Back to your original question, if you want to go wider in the rear, you are going to need wider wheels as well. Eleven inches wide seems right if you are going to 305 mm tire. Your wheel selection gets pretty slim at that width. You might have to go to a custom made wheel like Fikse for that. Last edited by Radiation Joe; 07-27-2008 at 12:14 PM. Reason: add comment |
![]() |
|
| 07-27-2008, 12:25 PM | #10 |
|
Brigadier General
![]() |
hmmmm.... I had the opposite experience at BW. high pressures (48) but tire temps in the 170 range. are your temps consistant accross the tread?
I ran 265 all the way around and was pretty happy. |
|
|
|
| 07-27-2008, 01:14 PM | #11 |
|
Dishonorable Discharged
|
Radiation,
Sorry I am running front and rear 18x10 ET25 on all four corners, I was doing something else and reading specs from a sheet of paper and not using my brain. I would also suggest running 3-5mm spacer on the front. Hoosiers might be a solution, but I will probably go to Toyo's next time. Anyone want a slightly used set of yoko's? cheap. Also Radiation this is a HEAVY car that I think is the tire size/heat problem. Especially the way I drive. say, across the tread was within 15 degrees. TC has camber plates just need to throw away the expensive adj. BMW shocks. |
![]() |
|
| 07-27-2008, 01:45 PM | #12 |
|
Brigadier General
![]() |
MArk - check out the BFG R1 tire - pretty impressive tires. they get better lap times than the Hoosiers and they last longer too. very consistant tire also after many laps. they may dissipate heat better? .
|
|
|
|
| 07-27-2008, 07:12 PM | #14 |
|
Hamann M3 Fan
Drives: 2008 E92 Jerez Black M3 Join Date: Feb 2008
Location: Killeen, Texas
|
Nate@IND car had these wheels on it 20x8.5 front with 245/30ZR20 tires and 20x11 rear wheel with 305/25ZR20 I am now the owner of these wheels and tires off this car. They had no problem with 305/25ZR20 size rear tires. The car was also lowered with H&R sport springs which I do have also and plan to put on my M3. I will put these wheels and tires on my M3 when I pick it up at the port around the first week of Aug. I will also post pics for sure
__________________
![]() JZB,6MT, My mods 360 Forged 20inch wheels,VF540 Supercharger,Hamann CF roof spoiler,H&R springs,CF grills,Hamann rear trunk spoiler,Hamann Side Skirts, ARKYM full CF bumper, Gintani Race exhaust, AA X-pipe catless,RPI scoops,AA SSK, JZB painted side grills w/tinted markers, Arkym CF Double Sided Vented Hood,Arkym CF rear Diffuser |
![]() |
|
| 07-27-2008, 07:50 PM | #15 | |
|
Veni Vidi Vici
Drives: '11 JB/BBe-6sp-e90 Join Date: Jul 2008
Location: Macungie PA
|
Quote:
As far as the stock shocks go .... I've told myself that THIS CAR WILL NOT BE MODIFIED. But, if you want the best performance you'll have to go to aftermarket (Koni 28s from TC Kline or ADs from GC). Then you're on that slippery slope to spherical bearings, 600 pound springs, etc.. I'll definitely get pads, and probably track rubber; and possibly some well chosen firmer bushings, but, I've decided that a dedicated track car is the only way to go. My e90 M3 will be a two year lease while I wait for the Audi D4 A8 to come over. At that point hopefully I should have a dedicated race car for track days. |
|
![]() |
|
| 07-28-2008, 09:24 AM | #16 |
|
Dishonorable Discharged
|
Shady1,
It would sure be nice if you could measure the offset and backspace on the rear wheel. That would help immensely. Radiation, I don't plan on larger than 285 front. I just hurts to think about the PCS wear/cost. TC still does not have a good E92 M3 system yet. I have a very well set up 02 MCoupe. I, unfortunately know very well about the slippery slope first hand. In fact that is my biggest frustration, the MCoupe will eat this car for lunch, and give you change. |
![]() |
|
![]() |
| Bookmarks |
| Tags |
| tires, traction, wheels |
| Thread Tools | Search this Thread |
|
|