|12-14-2013, 12:37 PM||#1|
Drives: bmw m3
Join Date: Feb 2010
USB MULF2 Retrofit - Help Needed
hey guys in some desperate need of help here if anyone has knowledge on this area.
I am trying to retrofit a MULF2High SVS to my e92 that has phone prep (640).
I am using the white block cable from the phone prep to the blue connection on the MULF (i didnt change any wires and noticed it got power)
The wires I have are as follows into the blue block:
36 - brown
33 - yellow
31 - grey
19 - black
21 - clear
17 - red/green
15 - red/black
3 - blue
1 - yellow
37 - white / yellow
38 - blue / white
46 - green
50 - grey/blue
I tried both this setup as well as a direct connection to the radio most wire for retrofitting a MULF2. I cant get INPA to identify it for the life of me. not sure whats wrong. I see the red light from the MULF come on momentarily then it shuts off.
Here is the pin config i am using for the MULF2 - taken from my Phone Prep package. Maybe its not wired correctly to provide constant power??
It lights up the fiber cable for about 30 seconds then turns off. I am unable to see the MULF in INPA and tool32. I get the error unable to communicate w control unit. It seemed like others on this thread were able to solve this. Any insights GREATLY appreciated.
|Thread Tools||Search this Thread|