Fuses for continuous power supply?

[cheweihu]

Hey guys,

I have this power control box for the car blackbox which needs to connect to ACC+ (ignition) and BATT+ (permanent, continuous power source), I've done some search however from the fuse diagram I couldn't really figure which ones are the permanets, which, I suppose, could be fuse for the hazards(didn't see on the diagram) and door lock(not sure). Cig lighter and interior lights are not continuous, by the way.



Thanks,

Jared

[THE TECH]

What is it that you are trying to hookup?

[cheweihu]

Originally Posted by THE TECH

What is it that you are trying to hookup?

Something like this onewhich can provide the car blackbox powers after engine is cut (to record after the car is parked) while not letting the camera drains the battery. (it can be set to shut down when it voltage is lower than certain point or by time)

Thanks,

Jared

[pepsih]

any update??? im on the same boat

[tom @ eas]

Originally Posted by cheweihu

Hey guys,

I have this power control box for the car blackbox which needs to connect to ACC+ (ignition) and BATT+ (permanent, continuous power source), I've done some search however from the fuse diagram I couldn't really figure which ones are the permanets, which, I suppose, could be fuse for the hazards(didn't see on the diagram) and door lock(not sure). Cig lighter and interior lights are not continuous, by the way.



Thanks,

Jared

All fuses will time out when the car enters sleep mode. Permanent +12V will need to be tapped off the JBE module:



Disregard the orange/green harness w/ terminal connectors, as this is related to something else.

PIN3 on the JBE module (left side connector, red/blue wire) will provide constant power for the PSW. PIN6 can be used for ground.