BMW M3 Forum (E90 E92)

BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read


Go Back   M3Post - BMW M3 Forum > E90/E92 M3 Technical Topics > DIY Guides/ Discussions
 
Lux Angel Eyes
Post Reply
 
Thread Tools Search this Thread
      01-07-2012, 11:03 PM   #1
robackja
Lieutenant
 
robackja's Avatar
 
Drives: 2008 Jeep Wrangler
Join Date: Nov 2010
Location: Boulder, CO

Posts: 402
iTrader: (0)

DIY: Race Ramps

So I needed some ramps to install my ///M Performance Exhaust. Race ramps are $200+. Blitz and other $25-$100 ramps get such terrible online reviews, I decided to make my own. I followed this design:



I got the following at Lowe's
  • 5 - 2"x12"x8' pressure treated boards
  • 2.5" deck screws with square heads
  • wood glue
  • 2" grip tape roll
  • wood finish
  • $1 paint brush

Tools used:
  • Jigsaw with angled base
  • Portable electric screw driver
  • Measuring tape
  • Drill bit for drilling pilot holes

You can ignore the hand saw, I went right to the jigsaw after about 2 minutes of getting nowhere fast.



Here is all the boards for one ramp, cut like the model shown above.



Glue the boards, each layer.



Drill pilot holes, and screw layers together.



Using two pieces of trim wood I had in a bucket of spare wood in the garage, I installed bumper stops at the end of the ramp.



Here is one ramp assembled.



Add grip tape to the bottom, one strip on each end.



Add grip tape to the edge of each step.



Drive up the ramp.




I went to 2x12x8 boards instead of 2x10x8 of the model, since 2x12 is really 1.5x11.5 in lumber dimensions, and the rear wheels of ZCP rims are 10-inches wide, so 11.5-inches is just a hair larger then the tire width.

Pros: Quality build, low-profile angle, handles wide tires, 7.5" of lift.
Cons: Weight. Each ramp must weight like 45 pounds. It is ridiculous.

I still haven't decided if I am going to stain the wood or not. Probably. I already used it to remove my OEM stock exhaust, as I am scheduled to receive my M performance exhaust this Tuesday, and I wanted to take the stock exhaust off ahead of time..

Here is the thread showing the removal of my stock exhaust: http://www.m3post.com/forums/showpos...0&postcount=47
__________________
2011.5 E92 ///M3 Space Gray; Fox Red & Blk; 6MT; ZCP; ZCV; ZP2; ///M Performance Exhaust (sold)
2012 VW Jetta TDI (sold)
2002 Subaru WRX (sold)

The World in 35mm
robackja is offline   United_States
0
Reply With Quote
      01-08-2012, 04:09 AM   #2
swhat
Lieutenant
 
Drives: '11 MW E92
Join Date: May 2010
Location: Bay Area

Posts: 459
iTrader: (1)

what was the total cost of this project?
swhat is offline  
0
Reply With Quote
      01-08-2012, 12:41 PM   #3
robackja
Lieutenant
 
robackja's Avatar
 
Drives: 2008 Jeep Wrangler
Join Date: Nov 2010
Location: Boulder, CO

Posts: 402
iTrader: (0)

project cost

Quote:
Originally Posted by swhat View Post
what was the total cost of this project?
Items I had to buy:
  • 5 - 2"x12"x8' pressure treated boards. $12.97 each
  • 2.5" deck screws with square heads. $8.68
  • 2" grip tape roll. $9.68
  • $1 paint brush. $1.15
  • jigsaw blade. $5.97
Total: $91.48 + tax.

Items I already had:
  • Jigsaw with angled base
  • Portable electric screw driver
  • Measuring tape
  • Drill bit for drilling pilot holes
  • wood glue
  • wood stain (left over from other projects)
  • wood trim pieces for bump stops on the end of the ramps (left over wood pieces from previous house project).
Not as cheap as I imagined it the night before (but isn't that always true for these types of projects?), but the ramps are really heavy duty, and they don't slide while driving up them (and I have a really slippery concrete garage floor).

I still think they are too heavy (maybe if I was doing it again, I would look at lighter, non-pressure treated lumber), and I would probably reduce the length of the ramps also. This design the length is 6.5 feet. So storing ramps that measure 6.5 feet x 1 foot x 7.5 inches, and weigh ~40 lbs each is a pain-in-the-butt for me, since I have a tiny one car garage currently.
__________________
2011.5 E92 ///M3 Space Gray; Fox Red & Blk; 6MT; ZCP; ZCV; ZP2; ///M Performance Exhaust (sold)
2012 VW Jetta TDI (sold)
2002 Subaru WRX (sold)

The World in 35mm
robackja is offline   United_States
0
Reply With Quote
      01-08-2012, 03:47 PM   #4
coogs08
Second Lieutenant
 
Drives: 2009 M3
Join Date: Aug 2011
Location: Pearland, TX

Posts: 262
iTrader: (2)

great job, thanks for sharing.
coogs08 is offline  
0
Reply With Quote
      01-08-2012, 06:11 PM   #5
armyav8tor
n1smo
 
armyav8tor's Avatar
 
Drives: E92 M3
Join Date: Apr 2008
Location: North Carolina

Posts: 1,425
iTrader: (1)

Garage List
Thanks for sharing. I thought about doing something similar but also thought it would be too heavy and bulky.
armyav8tor is offline   United_States
0
Reply With Quote
      01-08-2012, 06:54 PM   #6
Kyoshi71
Colonel
 
Kyoshi71's Avatar
 
Drives: 2010 M3 Coupe
Join Date: Jul 2006
Location: New York

Posts: 2,528
iTrader: (0)

You're off your rocker building that contraption. If you invested in the Race Ramps, they'd last a lifetime and are probably much lighter the what you have.
C'mon man, you spend $4,500 on a muffler but stop short at 2 hundie for Race Ramps?
__________________
"But resist we much; we must; and we will much; about that be committed."
~Rev. Al Sharpton


2010 E92 M3|Silverstone II|M-DCT|NCSW|2MT|ZCW|ZPP|ZTP|302|507|Gas Guzzler Tax
Kyoshi71 is offline  
0
Reply With Quote
      01-08-2012, 07:11 PM   #7
robackja
Lieutenant
 
robackja's Avatar
 
Drives: 2008 Jeep Wrangler
Join Date: Nov 2010
Location: Boulder, CO

Posts: 402
iTrader: (0)

Quote:
Originally Posted by Kyoshi71 View Post
You're off your rocker building that contraption. If you invested in the Race Ramps, they'd last a lifetime and are probably much lighter the what you have.
C'mon man, you spend $4,500 on a muffler but stop short at 2 hundie for Race Ramps?
Well, I only spent $3500 on the muffler.. haha. I don't really care about $200-$300 for ramps. I just wasn't super impressed with what was available for both price and quality, and thought I may be able to do better for less. Maybe if I had somewhere to see ramps in person beforehand I would of had a different opinion, but all that was available to me locally were those shitty Blitz ramps at autozone et al.

So, I gave it a shot, as a fun weekend project, and attempted DIY race ramps. I also wanted to share my experience here, since I have benefited from this forums on numerous occasions, and thought I could give back by posting my experience here.

In retrospect, my only gripe is the weight. If I knew what I know now, I would have probably just got these: Race Ramps RR-56 instead of building my own.
__________________
2011.5 E92 ///M3 Space Gray; Fox Red & Blk; 6MT; ZCP; ZCV; ZP2; ///M Performance Exhaust (sold)
2012 VW Jetta TDI (sold)
2002 Subaru WRX (sold)

The World in 35mm
robackja is offline   United_States
0
Reply With Quote
      01-08-2012, 07:31 PM   #8
armyav8tor
n1smo
 
armyav8tor's Avatar
 
Drives: E92 M3
Join Date: Apr 2008
Location: North Carolina

Posts: 1,425
iTrader: (1)

Garage List
Yeah, the Race Ramps are awesome. I store them on the top shelf in the garage because they hardly weigh anything. What you got going is pretty cool too, like I said, I thought about doing what you did also. Laziness got the better of me.

armyav8tor is offline   United_States
0
Reply With Quote
      01-08-2012, 07:37 PM   #9
Kyoshi71
Colonel
 
Kyoshi71's Avatar
 
Drives: 2010 M3 Coupe
Join Date: Jul 2006
Location: New York

Posts: 2,528
iTrader: (0)

Quote:
Originally Posted by robackja View Post
Well, I only spent $3500 on the muffler.. haha. I don't really care about $200-$300 for ramps. I just wasn't super impressed with what was available for both price and quality, and thought I may be able to do better for less. Maybe if I had somewhere to see ramps in person beforehand I would of had a different opinion, but all that was available to me locally were those shitty Blitz ramps at autozone et al.

So, I gave it a shot, as a fun weekend project, and attempted DIY race ramps. I also wanted to share my experience here, since I have benefited from this forums on numerous occasions, and thought I could give back by posting my experience here.

In retrospect, my only gripe is the weight. If I knew what I know now, I would have probably just got these: Race Ramps RR-56 instead of building my own.
Dude, I just realized something.....Forget about the F**KING RAMPS.....What about the M-P-E!!!!!!!!

I have it and it kicks ASS!!!!!!!!!!! Are you done with the job yet???
__________________
"But resist we much; we must; and we will much; about that be committed."
~Rev. Al Sharpton


2010 E92 M3|Silverstone II|M-DCT|NCSW|2MT|ZCW|ZPP|ZTP|302|507|Gas Guzzler Tax
Kyoshi71 is offline  
0
Reply With Quote
      01-08-2012, 07:40 PM   #10
robackja
Lieutenant
 
robackja's Avatar
 
Drives: 2008 Jeep Wrangler
Join Date: Nov 2010
Location: Boulder, CO

Posts: 402
iTrader: (0)

Quote:
Originally Posted by Kyoshi71 View Post
Dude, I just realized something.....Forget about the F**KING RAMPS.....What about the M-P-E!!!!!!!!

I have it and it kicks ASS!!!!!!!!!!! Are you done with the job yet???
I don't know what M-P-E is... and if you are asking if I have my performance exhaust on yet, the answer is no. It won't be here until Tuesday, according to UPS.com. I just have limited time this Tuesday and Wednesday, so I wanted to take the stock exhaust off ahead of time, so that I can try to put it on Tuesday evening in like 30 minutes

Edit: Duh, M-P-E == M Performance Exhaust.. haha, sorry I am idiot.
__________________
2011.5 E92 ///M3 Space Gray; Fox Red & Blk; 6MT; ZCP; ZCV; ZP2; ///M Performance Exhaust (sold)
2012 VW Jetta TDI (sold)
2002 Subaru WRX (sold)

The World in 35mm
robackja is offline   United_States
0
Reply With Quote
      01-08-2012, 07:44 PM   #11
Kyoshi71
Colonel
 
Kyoshi71's Avatar
 
Drives: 2010 M3 Coupe
Join Date: Jul 2006
Location: New York

Posts: 2,528
iTrader: (0)

Quote:
Originally Posted by robackja View Post
I don't know what M-P-E is... and if you are asking if I have my performance exhaust on yet, the answer is no. It won't be here until Tuesday, according to UPS.com. I just have limited time this Tuesday and Wednesday, so I wanted to take the stock exhaust off ahead of time, so that I can try to put it on Tuesday evening in like 30 minutes
M-P-E
M-Performance Exhaust.

It's an easy job
__________________
"But resist we much; we must; and we will much; about that be committed."
~Rev. Al Sharpton


2010 E92 M3|Silverstone II|M-DCT|NCSW|2MT|ZCW|ZPP|ZTP|302|507|Gas Guzzler Tax
Kyoshi71 is offline  
0
Reply With Quote
      08-03-2012, 07:21 PM   #12
RuthlessE90
First Lieutenant
 
Drives: FAST
Join Date: Mar 2011
Location: NYC

Posts: 324
iTrader: (5)

this is great
RuthlessE90 is offline   No_Country
0
Reply With Quote
Post Reply

Bookmarks

Tags
diy, exhaust, race ramps, wood, wooden

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 03:31 PM.




m3post
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST