Quote:
Originally Posted by stefan
Do not do this. If this is the same quality control I noticed (and mentioned above) then you really only need a very minor reduction. I'm talking basically just taking the outer curvature of the emblem off the lens side of it, making it flat/square. That's it. It's undetectable once installed. Filing your emblem is going to result in nightmares. Total amount to file is maybe 1mm. It's really minor after you've adjusted the screw and so forth. I only had one do this, by the way. The other was fine.
|
to each his own, both of my gills were short by 1mm as you can see from the pics i posted when i opened the thread. As long as you are careful, filing the ends of the emblem is not that noticeable either...