Hi,
Yes, I have searched! And found many useful threads. However I'm a bit unclear on a few things. I'm going to start from scratch with buying a new jack and 4x stands. What I used before is junk.
1) Jack suggestions? Any that can reach the center lift point without raising the car initially?
http://www.amazon.com/Advanced-Desig...d=6BES1759T2F4 I wouldn't want to spend much more than $300.
2) I know I need the
insert for the jack, but what do I need for the jack
stands? Typical stands have a mounting point that will need a piece of wood or something so the plastic jack points are not crushed. Are you guys just cutting 4 pieces of wood?
3) Torque wrench - 88lb/ft is what the wheels take? How about this wrench?
http://www.amazon.com/Snap-Industria...d=6BES1759T2F4 Something cheaper would be OK, too.
4) I know I need these:
http://www.ecstuning.com/BMW-E90-M3-...l_Tire/ES6225/
5) Suggestions on a rear jacking point are welcome.