Quote:
Originally Posted by aresh
when i had all 4 wires plugged in, my sub would never hit hard and they would almost always blow or my amp would over heat. The reasoning i have, your getting signal, a low pass signal from the two subs underneath, just one signal from one sub would give you a clear signal rather than having two signal pushed into one sub. the way i have mine setup is, pick any sub you want signal from and cut the other sub out. EX. right l7 subwoofer, right postive and right negative will go into your lci.
|
If you're only using one channel of the LC2i then you could only have one output on the RCA side of it right? Are you using a y-cable so the you can use both channels of amp?