[TNTMYM3]

If it has just penetrated the clear coat slightly then on the smaller stain area, I would first go with 1200g wrapped around a small 1” x 2” block and do an X pattern “low pressure” wet sand using a 50% alcohol and water solution for a few minutes, then go 1500g, then go 2000 and polish the area afterward to see what your results are. Hopefully it didn’t penetrate too deep but if it did just repeat until you learn how deep it went. The clear really doesn’t look all too discolored from your photos so I would say that just finding the right amount of depth to sand into and polish is your solution. Typically, a detailer that is familiar with cut and polish process can also be very helpful.