Quote:
Originally Posted by VP Electricity
He said he checked all his wiring and fixed it, but
I'm not exactly certain what he fixed - hopefully he posts that.
You would get a 10, that is correct.
Signal harness plugs in at the amp in the driver's rear corner, sub amp usually goes between wheel wells under floor, LC2 usually goes next to EP amp. Power harness to battery, speaker harness from amp to sub. Only wire cutting is when inserting our harness wires into the new amplifier terminals.
|
Basically, I had it wired wrong. When I went back and redid it all, I found my mistakes. So it was all user error on that one. I was initially confused cause one set of terminals on the LC2i were already wired but the other set wasn't. I took this to mean that they weren't needed and went about the install without messing with them. After looking everything over and rethinking it and checking the one other pic I could find with an LC2i wired in an E9x, I figured out the issue. Simple installer error. I'd never used a line output module before. Every system I've installed included doing a new headunit, so it was always straightforward.