Hi,
I'm in the market of buying a ESS VT1 SC kit for my M3 ( mid term, I likely will move to NYC first ).
I see big improvement potential for the cold air intake. Wouldn't it be possible to construct an air intake duct where the filter element is located higher and fits 100 % in this new duct ? The filter element should not be visible at all, IMO.
I would appreciate Roman chiming in, as well as in the
ESS VT1 vs ESS VT2 - IAT's http://www.m3post.com/forums/showthread.php?t=384858 temps thread.
Thank you in advance for your reply.
Eugen