Quote:
Originally Posted by roddyc
I believe it comes with an applicator which isn't all that great; using the brush should work better. Apply it on thin, and most importantly, do any cleanup you want to do with the betalink remover within 5 to 10 minutes. Once it dries, it is extremely difficult to get off. Also, be careful not to apply too much near the edges to avoid betalink oozing out. It's a little difficult to clean effectively around the edges while the spoiler isn't fully set. Having clamps on hand to hold down the ends of the spoiler while it sets may also be helpful as I had one end that didn't sit flush until I clamped it down despite the fact the spoiler was OEM.
|
Thanks all questions answered here!