I just installed a set of the StopTech Trophy 380mm front and 355mm rear kit!
I haven't put many miles yet, but I can already feel the improvement in pedal feel. The bite point feels higher up and slightly firmer. I can't wait to get this system on the track!
We did run into a minor issue where the front left corner was shuttering under braking. I e-mailed StopTech at 8pm that evening and Pat from StopTech e-mail be back that same evening! Excellent customer service!
It turns out sometimes after they change out the tooling, it can leave a finish or a burr that needs to be smoothened out. Sure enough after a few hard stops, it went away. Today I bedded in the pads and I didn't notice any shuttering.
I just wanted to share with you all some photos I took of the install.
Noah @ Cohesive Garage did the install and did a great job!
DSC_6508 by
onesixeight88, on Flickr
DSC_6263 by
onesixeight88, on Flickr
DSC_6278 by
onesixeight88, on Flickr
DSC_6308 by
onesixeight88, on Flickr
DSC_6324 by
onesixeight88, on Flickr
DSC_6342 by
onesixeight88, on Flickr
DSC_6398 by
onesixeight88, on Flickr
DSC_6409 by
onesixeight88, on Flickr
DSC_6425 by
onesixeight88, on Flickr
DSC_6435 by
onesixeight88, on Flickr
DSC_6437 by
onesixeight88, on Flickr
DSC_6439 by
onesixeight88, on Flickr
DSC_6446 by
onesixeight88, on Flickr
DSC_6458 by
onesixeight88, on Flickr
DSC_6476 by
onesixeight88, on Flickr
DSC_6488 by
onesixeight88, on Flickr
DSC_6482 by
onesixeight88, on Flickr
DSC_6533 by
onesixeight88, on Flickr
DSC_6549 by
onesixeight88, on Flickr