[tom @ eas]

1. Depress retaining barbs on headlight access cover with screwdriver and lift out of place


2. Locate OEM Angel Eye Connector Plug


3. Rotate bulb 90 degrees counter-clockwise (from front of vehicle) and remove from lamp


4. Remove bulb from connector using screwdriver to free retaining clips


5. Remove bulb


6. Route AiB lightsource into bulb housing


7. AiB lightsource in highbeam housing


8. Using softjawed pliers, slightly rotate AiB lightsource to lock into place


9. Route AiB lightsource power connector through supplied heatsink


10. Back out allen set screw with 5/64 wrench


11. Install heatsink onto AiB lightsource and lock into place with set screw


12. Plug AiB DriverPack into LightSource, connector is keyed to go in only one direction


13. Plug wires into OEM AE connection, wires are color-coded to to factory colors used on your BMW


14. Tuck wiring away from any high-seat sources or movable parts within lamp


15. Tuck DriverPack inside channel OUTSIDE of headlamp underneath radiator support away from view. DriverPack are potted design to resist elements. DO NOT INSTALL DRIVERPACK INSIDE HEADLIGHT HOUSING


16. Replace headlight access cover. No exposed wiring is seen with proper installation