I am confused now looking at dyno's done at Gintani. Why are the axis point where tq meets hp differ from run to run? Why are they not intersecting at 5252 rpm? If they have dyno'd many different M3s why can't they have a consistent scale to use all the time?
Original post
Original Post
Bone stock run, notice how its at 5252
Rpi Scoops, Fully catless Stock exhaust, Powerchip Stage 1, RD Sport Pulley
Rpi Scoops, Macht Schnell Air Filter, No cat stock X-pipe, RD SPort Pulley ,Gintani Rear section.
Original Post
Stock run Axis point is at approx 5700
After envy intake, note that after they leaned it out the axis point is shifting back from 6100 to 5800
Original post
Finally this one, notice this was on the same exact day but couple hours apart yet the axis point is way off.