Thanks!! (and a double-thanks for the prompt reply!) Where did you find that information, originally?
I found that the bolts were loose enough that I could further tighten them by hand, before I tried removing them.
BTW, I only did one of the fronts, so far, but the sleeves that house the retaining bolts were really wedged in place. I had to pry them out and then use a rubber mallet to get them back into position. Positioning them to line up with the holes was really a pain! I had to use a flashlight to figure out which direction to push it in, then use a small screw driver (inserted through the hole) to guide the sleeve in that direction while hitting with the mallet. I don't believe they're supposed to be so tight.
|