Help with INPA setup
So I'm just trying to get started coding on my 2008 E92 M3. Bought the $99 cable from one stop electronics and downloaded the ncsexpert package from the DIY. Everything is unzipped to C: drive and I've installed the obd driver as well as set up my enviroment variables and port settings per the DIY. Cable is plugged into OBD2 port and I start INPA. The attached image is all I get.
The top two dots in the left corner flash nonstop and I get nothing on Battery or Ignition. The green Running bar in the lower right continuously stays up. I tried to select my chassis and select the airbag module anyways and I get an interruption in communication error.
So what am I doing wrong here? I've followed the DIY to the T. I am running 64-bit Windows 7 so I'm running the software through the virtual machine and a windows XP emulator if that information helps.
|