03-26-2012, 01:17 PM
|
#18
|
BimmerPost Supporting Vendor
Drives: BPMsport 2012 E92 M3
Join Date: Jun 2011
Location: Kansas
|
Quote:
Originally Posted by aresh
when i had all 4 wires plugged in, my sub would never hit hard and they would almost always blow or my amp would over heat. The reasoning i have, your getting signal, a low pass signal from the two subs underneath, just one signal from one sub would give you a clear signal rather than having two signal pushed into one sub. the way i have mine setup is, pick any sub you want signal from and cut the other sub out. EX. right l7 subwoofer, right postive and right negative will go into your aftermarket amp.
|
Quote:
Originally Posted by aresh
Also with all 4 wires in, i could not run the LCi more than minimum, once i cut of the other L7 sub signal, i was able to set the gain of the LCi perfectly.
|
Quite interesting.
|
|
|