Quote:
Originally Posted by VP Electricity
After you mentioned this, I asked them if there had been any changes to the design, and Tech Support did not know of any.
|
So its interesting to compare the 600/4 specs to the 900/5 specs. I won't restate them all here but the interesting thing to note is that different loads have different effects between the two amps.
600/4 150w almost across the board
900/5 - supposedly LESS power to a 2ohm vs 4ohm load (75 vs 100w)?
Both supposedly have RIPS...I doubt it would be implemented differently in the respective amps.
Good news is that by bridging two 900/5 channels, I can have a perfectly power matched center