[dma550]

Hey all

I am very close to wrapping up my escort 9500CI install. So far I have the rear laser, front laser, front radar head, gps antenna all installed and all cables converge under the dash at the fusebox where I will mount the brain. It's been a huge amount of work that I did a little at a time, a few hours here and there.

Anyhow, I am now needing to mount the control module and the display module, which are both attached to a flat phone wire style wire with RJ14 head.

I need to get these two items to the drivers side. I haven't yet pulled apart the drivers side shrouds and covers, but I was wondering if anyone had any technique or wisdom to get the wires from fuse box area to where the steering wheel emerges? I am doing surface mounts with acrylic tape vs. anything destructive.

Thanks!