Quote:
Originally Posted by alarroyo
The jig I made was a 2 1/2" Black 3 pipe about 4 inches long, 1/2 all thread, 4 2" washers, 2 1 1/2" washers, 4 19mm nuts, and an old oil filter socket that goes over the pipe. The removal was very easy may be 15 minutes all three, putting them back was easy except one that gave me a little problem.
|
Quote:
Originally Posted by alarroyo
Most of the time was spent taking it apart and putting it back together.
|
Awesome! Thank you very much for sharing. Did you use the same jig on the front bushing as well?
Curiously, how might you tackle the subframe bushings if you were to do that?