Quote:
Originally Posted by Drews M3
i can dig it! 
what did you do exactly? Could you give a little detail on how you installed it? |
basically I wrapped it. I took a heat gun and heated it so that it was easy to mold and then made sure to leave enough room on both sides after forming it to stick behind the trim. Some parts took some time to work out all the wrinkles but it all comes out with heat. The key is to make sure that you do not stretch the fabric when trying to mold the inner parts because it will start to rise after a little time.
Tools needed are:
a razor
heat gun/blow dryer
and either use your hands or a 3M squeegee