Thread: help.......
View Single Post
      12-23-2010, 08:23 PM   #4
tha_good_life
Brigadier General
tha_good_life's Avatar
376
Rep
4,089
Posts

Drives: 21 X6MC
Join Date: Jul 2008
Location: Seattle

iTrader: (22)

Garage List
2021 BMW X6MC  [10.00]
2010 BMW M3  [8.68]
Quote:
Originally Posted by allen1999 View Post
hi,

is anyone here got the rear LSD noise after the first 2k inspection oil change ?? my m3 got that problem when i turn a corner very slow in 1st gear . is that normal ??
You must be referring to this service bulletin:

This Service Information bulletin supersedes SI B33 01 02 dated March 2008.

SUBJECT
Grinding Noise from the Differential during Slow Cornering

MODEL
E90, E92 and E93 M3 from start of production

SITUATION
A grinding noise may be heard coming from the differential during slow cornering. This noise is best heard during tight cornering situations; for example, while parallel parking, driving in a tight circle, etc.

CAUSE
When the rear wheel speed differential varies during tight cornering, a slip stick effect is created on the lining and steel discs incorporated in the differential locking clutch, causing the grinding noise. This noise typically goes away as the locking clutch discs in the differential are broken in.
The break-in time varies depending on driving habits; for example, tighter cornering (working the locking clutch) means that it takes less time to break in the locking clutch discs.

CORRECTION
If a customer complaint is verified as described above on the E46 M3; E60 M5; E63 and E64 M6; or on the E90, E92 and E93 M3 vehicles, the differential oil should be replaced with a specially formulated differential oil, BMW part number 83 22 2 282 583.
PROCEDURE
1. Drain the differential oil. Refer to the appropriate model repair instruction in TIS:
Main Group 33 / Subgroup 10 / RA 0011259.
2. Refill the differential with special differential oil as shown in the illustration below.
Differential fill capacity = 1.2 liters (1.3 quarts).
3. Road test the vehicle.
With the vehicle at operating temperature, drive in tight circles (20 circles in each direction), allowing the special oil to coat the locking clutch discs.
The grinding noise will decrease when the locking clutch discs are sufficiently coated. Some slight noises may still be heard after driving in tight circles. Advise the customer that it will be necessary to drive the vehicle up to 600 miles before all noises are eliminated.
Note: Vehicles that have had the differential oil converted to this special oil should continue to use this oil whenever a service requiring the differential oil replacement is indicated.
Appreciate 0