Quote:
Originally Posted by BzsBimmer
That specific bolt might be able to come out if you use some vice grips and clamp the bolt in the front and turn it as if you're tightening
The only other thing I can think of is to remove the lower arm and drill out the bolt. You'll need an alignment after.
|
Your first option wont work because the screw has very small portion out from the lower arm. I wont be able to hold it tight.
The only option is to drill it out but as you said it required removing the lower arm to do so.
If I had air gun, it would have been more easier to drill it out.
I don't understand when some say it is very easy DIY. It is NOT! If you don't have required tools and probably air gun, don't even attempt it.
Screws are tightened really hard and if it is rusted then you are more screwed