Moton Installation Question
Just got a set of Motons and have some questions. I would really appreciate anyone's help!
1) I am wondering if the kit is supposed to come with wrenches to adjust the ride height?
No. It can be ordered separately. Spanner wrenches are usually not needed.
2) On the front strut piston (1st pic), I noticed that the Moton kit came with a conical washer. Where is it supposed to go? Above or below the stock guidesupport? In what orientation? (see 3rd pic)
The washer is meant to center the strut piston because it is smaller in diameter vs. the stock support bearing. However, a sleeve has been added to the kit for easier installation.
3) In the rear (final pic), are parts 3, 4, 5, 6, 7 basically going to be replaced by Moton parts?
Yes.
Red are answers per James Clay at BimmerWorld.
Last edited by rzm3; 11-21-2009 at 12:52 AM..
|