Quote:
Originally Posted by kenwelch
Code p136f
BMW Fault Code Description VS-Text
M ignition coil, cyl. 3
BMW Fault Code (dez)
11113
BMW Fault Code (hex)
0x2B69
Calculated value Y/N
No Info.
Component
No Info.
Customer perception comments
CC message Engine speed limited Reduced power MIL after engine runs 2x
Fault debouncing
No Info.
MIL illumination/CC message/emergency program
MIL
Monitoring criteria
Idle: Combustion miss SA: Offset outside tolerance range
Possible Fault Causes
Internal malfunction in M coil
Remarks
Idle is stable: No KH intervention, all cylinders switched on, no miss detected, camshafts synchronous, K_VR_DIAG_LAM_MAX > lam_ist_mw_bx > K_VR_DIAG_LAM_MIN and deviation from tz_grund_bx < K_VR_DIAG_DTZ_MAX, tmot > K_VR_DIAG_TMOT_MIN and toel > K_VR_D
Repair procedures (plant/service)
Interchange ignition coils:
1.If the malfunction migrates with the coil, then the coil is defective
2.If the malfunction remains at the same cylinder, check the ignition wire and power supply. If no fault is present in the ignition wire or the power supply: Replace DME
Signal information
No Info.
Subcomponent
No Info.
System test
No Info.
Temperature conditions
No Info.
Terminal conditions
Terminal 15
Time conditions
No Info.
Voltage conditions
none
|
Exactly what was wrong. New ignition coil in my car.
Thanks for all the help!