|
I ended up blowing an SWS speaker that was run through the Technic Harness, LC2i and Zapco Amp. I tried switching channels around and it seems as though the right channel on the LC2i is also fried. I get very minimal response out of the right channel with the good sub, good response from the left channel, and no response from the bad sub on either channel of the amp or LC2i.
Need to make some more posts then message Technic. Need to see if I should get a Navone LOC to replace the LC2i. Fairly sure it blew because the gains were too high on the LC2i and not high enough on the amp.
|