Quote:
Originally Posted by Richard@M-World
I just measured a KW spring perch and it came in at 2.40" dia. Depending on the true ID of a 2.25" spring, it may or may not work, but most likely the latter.
|
I measured all of my 2.25" springs and the IDs were 2.25-2.27".
The only way it would work is if the lower spring perch/locking collars, helper/tender springs, and couplers are all changed - is it worth the additional cost or is there sufficient thread on the damper body to remove everything but the main spring and keep it seated at full droop?