Quote:
Originally Posted by warp10motorsports
Could you post some more detailed step by step?
|
There's not much to it.
Cut holes in the front, install inlets, connect 3" hose to the back, cut a hole in the wheel well liner, attach hose.
If you use the existing screw hole in the wheel well to line the port up, you'll be in the right spot.
The port comes into the wheel well about 3" higher than the front port.
I would suggest ordering some c-clip nuts ahead of time. Luckily I had a good variety on hand.
http://componentparts.co.uk/Spring%2...0Fasteners.htm