View Single Post
      06-20-2011, 11:00 PM   #33
elp_jc
Brigadier General
 
Drives: .
Join Date: May 2008
Location: .

Posts: 4,910
iTrader: (0)

Quote:
Originally Posted by m3heaven View Post
I'm curious to know where and why you would have to take off a bolt holding the differential to the subframe when installing an axleback exhaust?
Most people, and certainly most shops do it that way, because it literally takes 5 minutes to remove the axle back with the hangers in place. Then you can remove the hangers on the floor much easier, by rotating them back and forth with WD40. Snapping the rubber hangers off the shafts (without removing them with their brackets) is a real b*tch . And yes, that's exactly what I did the first time. If there's a next time, will definitely take the brackets off. Hope this helps.
elp_jc is offline   United_States
0
Reply With Quote