View Single Post
      03-17-2011, 01:03 PM   #24
elp_jc
Brigadier General
United_States
80
Rep
4,910
Posts

 
Drives: .
Join Date: May 2008
Location: .

iTrader: (0)

Quote:
Originally Posted by Eclipsis View Post
It's not a tight fit, it just doesn't fit. "Fit" means the retention mechanism works right out of the box, but that's not the case with your bulbs. If I have to shave down the prongs on $130 turn signal bulbs, you guys did something critically wrong with the design.

If you guys created a version two of the bulbs where they slid into the same position the stock bulbs do, then they'd be perfect. But as is, you have a product that no one should install for risk of damaging a very expensive headlight unit.
Ouch! But a very valid point. I just don't get how that can damage the headlight unit, but it obviously does. Not going to mess with that bulb; not worth it. Doesn't look that bad stock IMO. Good day.